Brother HL-2060 User Manual page 122

Note
Do not forget your pass number that you have used to lock the panel
switches. If you enter a wrong number, you cannot unlock them. The
display shows the following message:
INCORRECT!!
Auto Form Feed
If unprinted data remains in the printer's memory, the DATA lamp stays
on. You need to print out the remaining data with the FORM FEED
switch. See "FORM FEED Switch" in Chapter 4.
The auto form feed you can set in this mode menu allows you to print out
the remaining data without pressing the FORM FEED switch.
You can turn on or off the auto form feed in this mode menu as follows:
Display Message
AUTO FF=OFF
AUTO FF=ON
When you turn on the auto form feed as above, you need to set the wait
time in the following sub-setting menu:
Display Message
WAIT TIME= 1s
.
.
WAIT TIME=99s
CHAPTER 4 CONTROL PANEL
Auto Form Feed
Turn off the auto form feed. You need to
press the FORM FEED switch every time
data remains in the printer's memory.
(Factory setting)
Turn on the auto form feed. Every time data
remains in the printer's memory, the auto
form feed takes place after the wait time set
as below.
Wait Time
Set the wait time for the auto form feed.
The printer automatically prints out the
remaining data after the set wait time.
The wait time can be set from 1 to 99
seconds.
4–47