Restoring All Settings To The Factory Settings; Checking Job Status Or Cancelling A Scheduled Job; Sending A Fax Manually; Out Of Memory Message - Brother MFC-820CW User Manual

Chapter 5
Restoring all settings to the
factory settings
You can restore all the settings you have
changed to the factory settings. These
settings will stay until you change them again.
a
Press (Fax).
b
Press a or b to choose
Factory Reset.
Press OK.
c
Press 1 to choose Yes.
d
Press Stop/Exit.
Checking job status or
cancelling a scheduled job
You can check which jobs are still waiting in
the memory to be sent and cancel a job. (If
there are no jobs, the LCD shows
No Jobs Waiting.)
a
Press Menu.
b
Press a or b to choose Fax.
Press OK.
c
Press a or b to choose
Remaining Jobs.
Press OK.
Any waiting jobs appear on the LCD.
d
Press a or b to scroll through the jobs
and choose the job you want to cancel.
Press OK.
e
Do one of the following:
To cancel, press 1 to choose Yes.
If you want to cancel another job go
to step d.
To exit without cancelling, press 2 to
choose No.
f
Press Stop/Exit.
36

Sending a fax manually

5
Manual transmission lets you hear the
dialling, ringing and fax-receiving tones while
sending a fax.
a
Press
b
Load your document.
c
Pick up the handset of an external
phone and listen for a dial tone.
d
Dial the fax number you want to call.
e
When you hear the fax tone, press
Mono Start or Colour Start.
f
Replace the handset.
5

Out of Memory message

If you get an Out of Memory message
while scanning the first page of a fax, press
Stop/Exit to cancel the fax.
If you get an Out of Memory message
while scanning a subsequent page, you will
have the option to press Mono Start to send
the pages scanned so far, or to press
Stop/Exit to cancel the operation.
Note
If you get an Out of Memory message
while faxing and you do not want to delete
your stored faxes to clear the memory,
you can send the fax in real time. (See
Real Time Transmission on page 34.)
(Fax).
5
5