Remote Commands - Brother T74 Owner's Manual

Remote Commands

Follow the commands below to access features remotely. When you call the fax machine and enter
your Remote Access Code (1 5 9
remote control command.
Remote control commands
95 Change Fax Forwarding
Setting
1 OFF
2 Fax forwarding
4 FAX FWD No.
6 FAX STORAGE ON You can set FAX STORAGE ON or OFF.
7 FAX STORAGE OFF
96 Retrieve FAX
1 Memory Status List
2 Retrieve all FAX
3 Erase FAX in the
memory
97 Check the receiving status
1 DOC
98 Change Answer Mode
1 TAD
2 F/T
3 FAX
90 Exit
), the system will signal you with two short beeps to enter a
Detail Operation
If you hear one long beep, the change is accepted. If you hear
three short beeps, you cannot change it because the
conditions (ex. registering fax forwarding) have not been
completed. You can register your fax forwarding number by
using 4. FAX FWD NO. Once you have registered the
number, the machine will automatically turn to "FAX FWD
: ON" mode. Then, receive a Memory Status List by entering
961. Check the List to make sure the Fax Forwarding
number you registered is correct. Then enter the
confirmation command 955. Now the machine will start Fax
Forwarding.
You must use a remote fax machine in order to receive a List
or stored fax message(s).
If you hear one long beep, you can erase fax message(s) from
the memory.
You can check whether your fax machine has received any
fax message(s). If yes, you will hear one long beep. If no,
you will hear three short beeps.
If you hear one long beep, you can change the answer mode.
If you hear three short beeps, you cannot change it.
After a long beep, you can exit remote control.
Remote Fax Options (FAX-T74)
53