Brother T74 Owner's Manual page 52

The display will return to the desired Caller ID you selected.
- If you press Stop again, the machine will return to the current date and time display. You are
no longer in the call reply mode.
- Any problems or queries in using network services should be raised in the first instance with
your network operator(s).
- With Call Reply, automatic redial does not function in cases where the called party is busy or
doesn't answer.
Call Reply to DDI numbers via Caller ID
Calls derived from a caller ID number to destinations connected to a "Direct Dial Inward (DDI)"
private exchange system may fail to connect, or may be answered in the first instance by the called
premises' main switchboard rather than by the intended extension. Brother is not liable for any call
charges thus incurred.
Clearing the Caller ID Stored in Memory (Only for FAX-T76)
For the effective use of the memory, it is recommended that you should clear the Caller ID stored
into memory by pressing Erase when the display shows the number.
Printing Caller ID List
1
Press Menu/Set, 0, 1.
2
Press or to select PRINT REPORT, and press Menu/Set.
3
Press Start.
BT Call Sign (For U.K. Only)
This machine feature lets you use the BT Call Sign subscriber service which allows you to have at
least two separate telephone numbers on one phone line. Each phone number has its own distinctive
ringing pattern, so you know which phone number is ringing. This is one way you can have a
separate phone number for your machine.
Your machine has a BT Call Sign compatible distinctive ringing function, allowing you to dedicate
a second phone number (on the same phone line) just for receiving faxes.
You can switch it off temporarily, then turn it back on. When you get a new fax
number, make sure you reset this function.
To have your external TAD answer only the main number, the machine
must be in Manual Mode.
In FAX mode, the machine will answer all incoming calls on the line.
Setting the machine to work with BT Call Sign
1
Set the machine to MANUAL mode.
2
Press Menu, 0, 2. The screen displays the current setting of this feature.
3
Press or to select ON (or OFF).
4
Press Set.
5
Press Stop to exit.
46
Chapter 8