Brother MFC-295CN User Manual page 123

Error Message
Document Jam
DR Mode in Use
High Temperature
Hub is Unusable.
Init Unable XX
(If the LCD shows
error number 46,
see the error message
Clean Unable 46
in this table.)
Init Unable 46
Ink Low Black
Ink Low Yellow
Ink Low Cyan
Ink Low Magenta
Low Temperature
Media Error
Media is Full.
No Caller ID
Cause
The document was not inserted or
fed properly, or the document
scanned from the ADF was too
long.
The machine is set to Distinctive
Ring mode. You cannot change
the Receive Mode from Manual to
another mode.
The print head is too warm.
A Hub or USB Flash memory
drive with Hub has been
connected to the USB direct
interface.
See Clean Unable XX in this
table.
See Clean Unable 46 in this
table.
One or more ink cartridges are
near the end of their life. If a
sending machine has a color fax
to send, your machine's
'handshake' will ask that the fax is
sent as black & white. If the
sending machine has the ability to
convert it, the color fax will be
printed at your machine as a black
& white fax.
The print head is too cold.
The memory card is either
corrupted, improperly formatted,
or there is a problem with the
memory card.
The memory card or USB Flash
memory drive you are using
already contains 999 files.
There is no incoming call history.
You did not receive calls or you
have not subscribed to the Caller
ID service from your telephone
company.
Troubleshooting and Routine Maintenance
Action
See Using the ADF (MFC-295CN only)
on page 18.
See Document jam (MFC-295CN only)
on page 112.
Set Distinctive Ring to Off. (See Turning
off Distinctive Ring on page 44.)
Allow the machine to cool down.
A Hub or USB Flash memory drive with
Hub are not supported. Unplug the device
from the USB direct interface.
See Clean Unable XX in this table.
See Clean Unable 46 in this table.
Order a new ink cartridge. You can
continue printing until the LCD shows
Cannot Print. (See Ordering
accessories and supplies on page ii and
Replacing the ink cartridges on page 116.)
Allow the machine to warm up.
Put the card firmly into the slot again to
make sure it is in the correct position. If the
error remains, check the media drive (slot)
of the machine by putting in another
memory card that you know is working.
Your machine can only save to your
memory card or USB Flash memory drive
if it contains less than 999 files. Try
deleting unused files to free some space
and try again.
If you want to use the Caller ID feature call
your telephone company. (See Caller ID
on page 44.)
B
109