Brother MFC-295CN User Manual page 116

Menu Setting Difficulties
Difficulty
The machine beeps when you try to
access the Setup Send or Setup
Receive menu.
Copying Difficulties
Difficulty
Cannot make a copy.
Copies are blank.
Vertical streaks appear in copies.
Poor copy results when using the
ADF. (MFC-295CN only)
Vertical black line appears in
copies. (MFC-295CN only)
Fit to Page does not work properly. Make sure the document is not skewed on the scanner glass.
Scanning Difficulties
Difficulty
TWAIN/WIA errors appear when
starting to scan.
OCR does not work.
Fit to Page does not work.
Poor scanning results when using
the ADF. (MFC-295CN only)
Software Difficulties
Difficulty
Cannot install software or print.
'Device Busy'
Cannot print images from
FaceFilter Studio.
102
Suggestions
If the Fax key is not illuminated, press it to turn on Fax mode. The Setup
Send or Setup Receive setting is available only when the machine is in Fax mode.
Suggestions
Make sure that the Copy
on page 58.)
Make sure you are loading the document properly. (See Loading documents
on page 18.)
If you see vertical streaks on copies, clean the scanner. (See Cleaning the
scanner on page 119.)
Try using the scanner glass. (See Using the scanner glass on page 19.)
Vertical black lines or streaks on copies are typically caused by dirt or correction
fluid on the scanner. Clean the glass strip and scanner glass and the white bar and
white plastic above them. (See Cleaning the scanner on page 119.)
Reposition the document and try again.
Suggestions
Make sure the Brother TWAIN/WIA driver is chosen as the primary source. In
PaperPort™ 11SE with OCR, click File, Scan or Get Photo and click Select to
choose the Brother TWAIN/WIA driver.
Try increasing the scanner resolution.
Make sure the document is not skewed on the scanner glass. Reposition the
document and try again.
Try using the scanner glass. (See Using the scanner glass on page 19.)
Suggestions
Run the Repair MFL-Pro Suite program on the CD-ROM. This program will repair
and reinstall the software.
Make sure the machine is not showing an error message on the LCD.
To use FaceFilter Studio, you must install the FaceFilter Studio application from
the CD-ROM supplied with your machine. To install FaceFilter Studio see the
Quick Setup Guide.
Also, before you start FaceFilter Studio for the first time, you must make sure your
Brother machine is turned on and connected to your computer. This will allow you
to access all the functions of FaceFilter Studio.
key is illuminated. (See Entering Copy mode