Selecting The Parts To Perform; Assigning Functions To The [1]-[10] Buttons - Roland Jupiter-Xm Reference Manual

Reference Manual Ver. 1.5 and later

Selecting the Parts to Perform

Here's how to select the parts that you'll perform from the keyboard.
1 .
Press the [PART] button .
The [1]–[16] buttons switch to part select mode.
2 .
Press the [6]–[10] buttons
on/off .
Parts that are on are shown with a
When a [6]–[10] button is lit, SCENE ZONE EDIT
of the corresponding part turns
keyboard.
Assigning Functions to the [1]–[10] Buttons
The JUPITER-Xm lets you assign the desired functions to the
buttons in part select mode.
1 .
Press the [MENU] button .
2 .
Use the [1] knob to select
[ENTER] button .
You can also make this selection by using the
instead of the [1] knob.
3 .
Use the [1] knob to select the
the [2] knob to change the value .
You can assign the functions that occur when you press the
buttons or the [6]–[10] buttons, and the functions that occur when
you hold down the [SHIFT] button
[6]–[10] buttons.
Parameter Value
[1] knob [2] knob
No Assign
PartSel
1-5,
Part+KeySw
1-5+ (S),
6-10,
KeySw
6-10+ (S)
PartSw
ArpSw
EfxSw
* The "+(S)" following the parameter name means
button."
4 .
To save the changes, press the
A confirmation message appears.
If you decide to cancel, press the
5 .
To execute, press the [ENTER]
16
to switch the performance parts
"K. "
"Keyboard Sw" setting
"ON, " allowing you to play it from the
[1]–[10]
"SYSTEM," and then press the
PAGE [ ] [ ] buttons
"PART Btn Asgn" item, and use
[1]–[5]
and press the [1]–[5] buttons
Explanation
Nothing is assigned.
Select the current part.
Simultaneously turn on/off the parts that
play and turn on/off the performance
parts.
Turn on/off the performance parts.
Turn on/off the parts that play.
Turn on/off arpeggio performance.
Turn on/off effects.
"while pressing the [SHIFT]
[WRITE] button .
[EXIT] button.
button .
or the