Motion Detection - Asus Mimic CX-200 User Manual

Hide thumbs Also See for Mimic CX-200:
Table of Contents

Advertisement

2.4.2 Motion Detection

This page allows the Administrator to set Motion Detection functions for the cameras.
i.
Camera A (or Camera B)
Enable
The Administrator has two options for Motion Detection;
a. Always On or
b. On Schedule, the Administrator can set up to 4 different time slots for
motion detection.
Note:
Check that you have setup valid Email / FTP accounts first before proceeding with
the rest of the configuration.
To setup Email / FTP, see Section 2.4.4
Detection Sensitivity
This will determines the level of change before motion capture is triggered. A
high percentage means a small change will trigger motion capture.
Send image every ... second(s)
Select either; 0.5, 1, 2, 3, 4 or 5 seconds.
Stop sending after ... email(s) or image idle for ... second(s)
ASUS Mimic will stop sending emails on the lower of the two conditions. The
Administrator can set between 1, 3, 5, 7 and 10 seconds. Emails can be set
from 1 to 99999 pieces or 0 for stop sending email only when image idle
occurred.
ASUS Mimic - user manual
Fig.26. Motion Detection page
Chapter 3: Web Interface
-23-

Advertisement

Table of Contents
loading

Table of Contents