Cable Idc; Crimping Process-Method 1 - FCI OCTIS 10135748-101LF Application Specification

NUMBER
GS-20-0454
TITLE
OCTIS PLUG KIT ASSEMBLY – HYBRID, SIGNAL & POWER
Step 5

Attach the copper tape (1.5 turn) (Fig 19)
Step 6

Remove the foil (Fig 20)

When cutting away the foil, make sure that no wires of the braid are being damaged
Step 7

Remove the plastic foil

When cutting away the foil, make sure that no wires of the braid are being damaged
10.3

Cable IDC

General Tooling Setup:

For application tooling see Chapter 9.

Read the manual before setting up.
10.3.1 Crimping Process – Method 1
HDXS Octis Cable Connector)
Step 1
First place the connector housing into the nest or positioning body. (Fig 22)
Copyright FCI
Form E-3334
Rev F
TYPE
APPLICATION SPECIFICATION
Figure 19
Figure 20
(by using 10135856-001, IDC table top pistol for Metral
Form E-3334
Rev F
PAGE REVISION
19 of 30
AUTHORIZED BY DATE
Stalin Alosius 2019-09-12
CLASSIFICATION
UNRESTRICTED
PDS: Rev :D STATUS:Released
D
Printed: Sep 18, 2019