Self Test; Self Test Procedure; Printing The Bluetooth Device Name And Mac Address - Star Micronics SM-S230I Series Hardware Manual

3.2 Self Test

You can use a self test to check the printer's settings.
Before you start the self test, make sure that roll paper has been properly loaded into the printer.

3.2.1 Self Test Procedure

1. Turn the printer power by holding down the FEED button and the POWER button simultaneously for
5 seconds or more.
2. The printer will print the current printer status, including the firmware version, communication mode,
and print settings.
3. The self test will finish automatically. The printer will be ready to receive data after the self test finishes.

3.2.2 Printing the Bluetooth Device Name and MAC Address

1. Follow the procedure in section 3.2.1 to perform a self test.
2. Before the self test finishes, press and hold FEED button and MODE button at the same time.
3. The printer will print the Bluetooth device name and MAC address (the contents up to the memory
switch setting information in case of the StarPRNT), and the self test will finish automatically. The
printer will be ready to receive data after the self test finishes.
Emulation : ESC/POS
Communication Port : Bluetooth(Auto)
Self test information
Bluetooth device name
and MAC address
Memory switch
setting information
- 21 -
Emulation : StarPRNT
Communication Port : Bluetooth (Auto)