Memory Switch Setting - Star Micronics SM-S230I Series Hardware Manual

3.3 Memory Switch Setting

For details on the printer settings, refer to "[Setting Table] (Page 27)".
The setting change by memory switch is disabled before shipment.
Before changing the printer setting by the memory switch, enable the setting change by memory switch
using the following steps.
1. Turn on the printer power by pressing and holding down the FEED button and the POWER button
simultaneously for 5 seconds or more. The printer will perform self printing.
2. After the self test finishes, release the POWER button and the FEED button, and press the POWER and
FEED buttons simultaneously within 2 seconds. Hold down both buttons for 2 seconds or more and
release the buttons.
Self test finishes
3. If the printer prints out "Memory SW setting = Enabled", the setting change by memory switch is
enabled.
* When the above steps 1 to 3 are performed while the setting change by memory switch is enabled,
the printer prints out "Memory SW setting = Disabled" and the setting change by memory switch is
disabled.
(By the buttons on the printer.)
5 seconds
Release the FEED button
and the MODE button.
Emulation : ESC/POS
Communication Port : Bluetooth(Auto)
Start self test
Within
2 seconds
- 22 -
Then, press the FEED and MODE
buttons simultaneously.