Table of Contents
Advertisement
GBC 4064WF
Figure 2
Figure 3-1
Figure 3-2
© 2005 General Binding Corporation
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
To use the NIP Roller Shim Dial:
A
Raise the Rollers (Main Hot Roller, Pull
Roller or both) using the Main Roller (Up
and Down) or Pull Roller (Up and Down)
Switch on the Control Panel.
B
Adjust the Roller Heights to the desired
Setting with the nip roller Shim dial and
Lower the Upper Roller back down to the
Laminating Position.
Note:
The NIP Roller Shim dials should be used in
Pairs for Adjustment settings of the desired
Rollers
Do not use the adjustments independently.
The left and right side of shim setting for
each roll must be at the same setting.
Media Tables: (Fig. 2A)
D
On both the front media and rear media
tables, the safety interlock switch will not
allow the laminator to operate at full speed
unless the tables are properly installed.
B
The Media tables are used to Position items
for Lamination. There are Two Media Tables
on the machine, one on the front & one on
the rear of the Laminator. Media tables
incorporate an Idler on the leading edge of
the table. This is used for Roll to Roll
E
applications during lamination
Note:
C
The Laminator will operate only when the
Media Table and Media Table Latches are
Properly Installed.
F
The Accessories Include:
1. Straight Slitter - Used for Slitting the
Media after lamination -Rear Table.
(Fig. 2B)
2. Feed Guide - Used for guiding Media
through the laminator. (Fig. 5B)
3. Pressure Plate - Used for guiding stock
and ensuring a wrinkleless feed into the
roller Front table. (Fig. 10A)
Swing out Film Unwind Shafts:
(Fig. 3-1B, 4A & 5A)
The Swing out film unwind shaft is used to
A
provide tension to materials going into the
lamination rollers.
There are three swing out film unwind shafts
present on the machine, two are located on
top of the machine, and the other one is
located below the front table.
(Fig. 3-1 Item B)
Lower Tension Idler: (Fig. 3-2 Item A)
Lower tension idler guides the lower
lamination film onto the lower rollers.
Operation Manual
Page 9
Advertisement
Table of Contents
