Table of Contents
Advertisement
Maintenance
Remote Control Battery Replacement
1. Depress tab and pull out to release battery compartment on bottom of the remote
control.
2. Correctly install one 3 Volt (CR2032 [longer life] or CR2025) battery in the
battery compartment
3. Insert the battery compartment.
Battery must be recycled or disposed of properly. Check with your Local
Authority or Retailer for recycling advice in your area
WARNING: Disconnect power and allow heater to cool before attempting any maintenance or cleaning to reduce
the risk of fire, electric shock or damage to persons.
Partially Reflective Glass Cleaning
The partially reflective glass is cleaned in the factory during the assembly operation. During shipment, installation,
handling, etc., the partially reflective glass may collect dust particles; these can be removed by dusting lightly with a
clean dry cloth.
To remove fingerprints or other marks, the partially reflective glass can be cleaned with a damp cloth. The partially
reflective glass should be completely dried with a lint free cloth to prevent water spots. To prevent scratching, do not
use abrasive cleaners.
Fireplace Surface Cleaning
Use only a damp cloth to clean painted surfaces of the fireplace. Do not use abrasive cleaners.
The fireplace should not be operated with an accumulation of dust or dirt on or in the unit, as this can cause a build
up of heat and eventual damage. For this reason the heater must be inspected regularly, depending upon conditions
and at a minimum yearly intervals.
Servicing
Except for installation and cleaning described in this manual, an authorized service representative should perform
any other servicing.
Figure 20
Push
Remove
19
Advertisement
Table of Contents
