Table of Contents
Advertisement
Installation
Mirrored Glass Installation
1. Attach the provided suction cup to the reflective
side of the mirrored glass. Ensure the suction cup is
securely attached.
2. Using the suction cup to assist, lift the mirrored glass
and place it into the bottom crevice at an angle.
3. Tilt the glass up into position. The mirror will remain at
a slight angle by design.
4. Secure the mirror using the mirror retaining brackets
and screws provided. (Figure 14)
CAUTION: Ensure the mirrored glass does not fall
forward while the mirrored glass mounting brackets
are being installed.
5. Remove the suction cup and clean any fingerprints or
debris off the glass with a non-abrasive glass cleaner.
!
NOTE: Do not dispose of the suction cup! Keep it in a
secure location, as it may be needed for maintenance
and service on this fireplace.
Figure 15
Figure 16
14
(Figure 13)
Figure 13
Figure 14
Mirrored Glass Bracket
(Quantity varies by model)
Media Installation
1. Position the media bed and secure it using the
provided brackets and screws. (Figure 15)
2. Disperse the provided acrylic crystals evenly across
the media bed.
It is possible to use custom media ornaments to
decorate your firebox. The custom media must fit
easily without scratching the glass or bowing the
media bed, and must not be composed of sand or
liquid, which could interfere with the safety of the
firebox.
www.dimplex.com
Advertisement
Table of Contents
