Table of Contents
Advertisement
Installation
Recessed Installation
1. Remove the side cover panels from the fireplace by
removing the 5 screws on each of the cover panels
(4 on the back of the fireplace, 1 on the bottom).
(Figure 2)
2. If a trimless installation is desired, remove pre-
installed trim by removing the screws (number of
screws will vary by model). (Figure 3)
!
NOTE: The pre-installed trim helps conceal
imperfections in the drywall edges against
the fireplace and gives the fireplace a finished
appearance.
3. Prepare a framed opening, following the dimensions in
the table below. (Figure 4)
Framing Dimensions
Width
Model
A
37"
PLF3614-XS
940 mm
43"
PLF4214-XS
1092 mm
51"
PLF5014-XS
1295 mm
61"
PLF6014-XS
1549 mm
CAUTION: This fireplace is NOT load-bearing. Ensure
the opening for the fireplace is framed in such a way
that the weight of the building materials will not create
pressure on the top of the fireplace.
!
NOTE: Wiring is performed at the bottom right back
corner of the firebox. (Figure 5) Plan the framing to
allow routing the power cable to this location.
4. Install and finish drywall as desired.
5. Remove the 3 screws that secure the electrical cover
to complete the wiring. (Figure 5)
6. Complete the wiring according to instructions in the
Electrical Installation section (pp. 12-13). Reinstall the
electrical cover after wiring is complete.
7. Lift the firebox into the opening in the framing.
8. Level the firebox. A bubble level is included in the
hardware kit provided.
10
Depth*
Height
(mininum)
B
C
4"
19"
102 mm
483 mm
* Includes
1/2" drywall
Figure 2
Figure 3
Figure 4
C
Figure 5
Electrical Cover
A
B
www.dimplex.com
Advertisement
Table of Contents
