Using Dump Mode In Ipl - Intermec UVE 10 PB21 User Manual

As long as a continuous string of characters is being received, the
program wraps the lines until the label is full and then starts to print
another label. After each character transmission, this information
prints:
•
•
•
When you exit Dump mode, a final label prints to inform you that it is
exiting from Dump mode.

Using Dump Mode in IPL

When you enter Dump mode, the printer captures incoming
characters on the communication ports and prints them on one or
more labels.
If you have IPL firmware on your printer, you can access Dump mode
in two different ways with slightly different results:
•
•
To enter Dump mode from the Setup menu
2 Press
3 Press
4 Press
5 Press
6 Cold boot the printer to exit Dump mode. For help, see the next
PB21 and PB31 Mobile Receipt Printer User Guide
Calle Llanos de Jerez 18 Nave 9 Coslada https://v10consumibles.com Tel: 910 269 309
Chapter 3 — Troubleshooting and Maintaining the PB21 and PB31
Page number
Number of characters printed on the label
Total number of characters received so far
You can access Dump mode through Test mode or Extended Test
mode and you will receive printouts that look exactly like those
produced with the Line Analyzer program in Fingerprint. For
more information, see the previous procedure,
Analyzer in Fingerprint" on page
You can access Dump mode from the Setup menu. If you access
Dump mode this way, characters are printed on a continuous line
along with corresponding hexadecimal numbers.
1 Press the Setup button.
until you reach Test/Service.
to enter the Test/Service menu.
until you reach Data Dump and then press
to select Yes and then press
procedure, Resetting the
V10 CONSUMIBLES S.L.
50.
.
Printer.
"Using the Line
.
51