Intermec UVE 10 PB21 User Manual page 33

3 Release both buttons. The printer performs a test feed (sensor
4 Press Feed to exit Dump mode.
After you exit Dump mode, the printer returns to Ready mode. For
more information on Dump mode, see
Communication Problems" on page
Using Extended Test Mode
Use Extended Test mode to run additional diagnostic tests, entering
Dump mode, and resetting to factory defaults.
Sample Extended Test Mode Screen
To enter Extended Test mode
2 Press the media cover release button to open the media cover.
3 Press the Standby button to turn the printer off.
4 Press Feed and Standby buttons at the same time until CLOSE
5 Close the media cover. You are now in Extended Test mode:
PB21 and PB31 Mobile Receipt Printer User Guide
Calle Llanos de Jerez 18 Nave 9 Coslada https://v10consumibles.com Tel: 910 269 309
Chapter 1 — Using the PB21 and PB31 Mobile Receipt Printer
calibration), prints, and then enters Dump mode.
The printer is now in Dump mode and it scans the
communication ports. Any characters received on the
communication ports are printed.
TEST LABELS
OK
CHESS
1 Make sure that the printer is loaded with media.
PRINTER DOOR appears on the screen.
• Press to cycle through the options.
• Press to select a test option.
• Press to exit Extended Test mode.
V10 CONSUMIBLES S.L.
"Troubleshooting
50.
23