Table of Contents
Advertisement
Maintenance
Note: Determine the left and right sides of the machine from the normal operating position.
WARNING
While maintenance or adjustments are being
made, someone could start the engine.
Accidental starting of the engine could seriously
injure you or other bystanders.
Remove the key from the ignition switch, engage
parking brake, and pull the wire(s) off the spark
plug(s) before you do any maintenance to the
unit or spreader attachment. Also push the
wire(s) aside so it does not accidentally contact
the spark plug(s).
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Before each use or daily
Periodic Maintenance
Check for Loose Hardware
Service Interval: Before each use or daily
1.
Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2.
Visually inspect machine for any loose hardware
or any other possible problem. Tighten hardware
or correct the problem before operating.
Maintenance Procedure
• Check for loose hardware.
• Clean the debris build-up from the machine.
Adjustments
Spreader Pattern Control
Cable Adjustment
To adjust the spreader pattern control cable:
1.
Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2.
Close the granular gate.
3.
Make sure the spread pattern control handle is
pushed down and locked at the control panel.
4.
Loosen the jam nut at the end of the cable.
21
Maintenance
Advertisement
Table of Contents
