Table of Contents
Advertisement
Operation
Spreader Pattern Adjustment
If the spread pattern is skewed or dispensing too
light/heavy to one side (see Figure 19 ), adjust the
gate as follows:
1. Heavy to left side
2. Move ramp pattern to
shaded position
Note: Do Not adjust the ramps to split product flow.
Use only the front or rear ramp positions as shown.
1.
Unlock the spreader pattern control knob by
turning it counterclockwise 90 degrees.
1. Spreader pattern control
knob
To adjust when the grass seed pattern is heavy:
Figure 19
3. Heavy to right side
Figure 20
2. Control handle
• to the left side, slightly pull the control handle
rearward.
• to the right side, slightly push the control
handle forward.
2.
Lock the spreader pattern control by turning the
control knob clockwise 90 degrees.
Operating Tips
Over Seeding
Important: Do Not put down more seed than
recommended by the seed company. Over
seeding can cause the grass to be too thick and
g025543
cause it to be susceptible to fungus.
Note: The machine will seed at the same rate going
both forward and rearward.
Note: If there is excessive thatch, it may be necessary
to remove the thatch prior to seeding.
Removing the Spreader
Attachment
1.
Stop engine, wait for all moving parts to stop,
engage parking brake, and remove the key.
2.
Unplug the spreader accessory harness (reference
Figure 9).
3.
Disconnect the cable ball joint from the control
lever (reference Figure 6). Loosen the knob on
the cable mount bracket.
4.
Remove and retain the hitch pin from the receiver
(reference Figure 4)
5.
Remove the hopper assembly, control cable, and
accessory harness.
Note: All other spreader attachment components
g207877
may stay mounted on the machine. Make sure
components are secure and away from moving
parts.
20
Advertisement
Table of Contents
