Operation; Controls - Exmark 135-0192 Operator's Manual

Spreader accessory
Table of Contents

Advertisement

Operation

Note: Determine the left and right sides of the
machine from the normal operating position.
Important: The intended use of this spreader
attachment is for dispersing grass seed. This is
not to be used for fertilizer or any other chemical
applications.

Controls

Impeller Speed Control
Located at the top of the spreader accessory control
panel (see Figure 13).
Push down on the right side of the switch one time
to turn the spreader "ON"; continue to tap the right
side to increase the impeller speed.
Tap the left side of the control to decrease the speed;
push and hold the left side of the switch to turn it
"OFF".
Note: The impeller speed control can be turned off
at any speed rate. It is not necessary to decrease the
speed until it turns off. The last set speed will display
when the control is powered back on.
Figure 13
1. Impeller speed control
2. Impeller speed display
g207672
3. Distribution limit lock
knob
4. Flow control lever
Impeller Speed Display
Located below the impeller speed control.
This display shows the speed setting number from
1–10 (1 is the slowest speed and 10 is the fastest). A
circle will display when the control has been turned
off.
Flow Control Lever
Located to the right of the main controls.
Lift the lever upward to start the flow and continue
lifting it to increase the distribution rate. Pull the lever
downward to decrease or stop the distribution rate.
Distribution Limit Lock Knob
Located on the right panel of the spreader accessory
control panel.
This knob is used to limit the maximum amount
of grass seed being dispensed to help maintain
consistent distribution.
Side Deflector Control Lever
Located on the left side of the hopper (see Figure 14).
1. Side deflector control
lever
Use the side deflector control to temporarily stop or
deflect grass seed away from sidewalks, parking lots,
patios, or anywhere grass seed is not desired to be
discharged from the left side of the spreader.
To temporarily deflect the grass seed, lift the lever
up and pull outward until the notch can be seated
into the lower narrow portion of the bracket; side
deflector lowers (see Figure 15).
15
Operation
Figure 14
2. Side deflector
g207876

Advertisement

Table of Contents
loading

Table of Contents