Table of Contents
Advertisement
Setup
Outer cover hidden for clarity
1. Aerator 30 installation
2. 1/4 inch flanged nyloc
nut
3. 1/4-20 x 5/8 inch hex
screw
4.
3/8-16 x 1 1/4 inch hex
screw
2.
Place the flow control panel onto the aerator and
secure using the hardware shown in Figure 3.
Note: There is additional hardware in the bolt
bag if the retained hardware is not long enough to
mount the control panel.
Figure 3
5. Reuse retained
hardware
6. Aerator 24 installation
7. 5/16-18 x 3/4 inch
flanged hex screw
8. 5/16 inch flanged nyloc
nut
2
Installing the Hopper
Assembly
Parts needed for this procedure:
Procedure
1.
Insert the hopper hitch tube into the receiver on
the aerator.
1. Hopper hitch tube
g239068
2. Hitch pin
2.
Use the hitch pin and cotter pin to secure the
hopper assembly to the aerator.
3
Installing the Cable Mount
Bracket
Parts needed for this procedure:
Procedure
Choose the appropriate cable mount bracket from
the bolt bag by matching the holes to the right side of
the aerator. Use the hardware shown in Figure 5 to
install the bracket.
10
Figure 4
3. Cotter pin
g213510
Advertisement
Table of Contents
