Assembly - Bissell PROHEAT ESSENTIAL Manual

Assembly

The only tool you will need to assemble your
cleaner is a Phillips head screwdriver.
1. Slide handle assembly onto lower body and
secure with two long screws.
2. Attach upper hose rack to back of handle
assembly by guiding the hook up into slot
location and pressing firmly upward until it
is seated flush with the back of the machine.
Secure 1 short screw through the hole in the
bottom of the upper hose and cord rack.
3. Attach lower hose rack by guiding the hook
up into slot location and pressing firmly upward
until it is seated flush with the back of the
machine. Secure 2 short screws through holes
on either side of the bottom hose and cord rack.
4. Attach Tough Stain tool to end of hose.
5. Wrap flex hose around hose and cord rack
and secure it into notch on holder and wrap cord
around opposite side of hose and cord rack.
6. Place tank in the bottom of the machine.
Before you clean
1. Plan activities to give your carpet time to dry.
2. Move furniture to another area if cleaning an
entire room (optional).
3. Vacuum area with a dry vacuum cleaner
before deep cleaning.
4. Plan your cleaning route to leave an exit path.
It is best to begin cleaning in the corner farthest
from your exit.
5. Pretreating (optional)
Pretreating is recommended to improve cleaning
effectiveness for heavily soiled carpet in high
traffic areas such as entry ways and hallways.
To pretreat:
a. Using the BISSELL Stain Pretreat,
generously spray evenly over soiled
area, do not overwet.
b. Wait 3-5 minutes before deep cleaning.
c. Clean as normal using your BISSELL
deep cleaner.
WARNING
Do not plug in your deep cleaner until
you are familiar with all instructions and
operating procedures.
1
2
4
ATTENTION
Some Berber carpets have a tendency to fuzz with wear.
Repeated strokes in the same area with an ordinary
vacuum or deep cleaner may aggravate this condition.
www.BISSELL.com
3
5
5