Nokia NSB-7 Series Service Manual page 195

PAMS Technical Documentation
User can select parallel port to be used when flashed.
During flashing status dialog is showed. After phone is flashed current time in PC is set
to phone and user is asked to check that the time is correct. If flashing succeeded "Flash-
ing completed!" message is shown to user, if flashing failed "Flashing failed" message is
shown instead.
After flashing phone several self-test are checked or run. If some of those fail, then Flash
Id, factory sets or user settings are not written to phone. For example if SW Version fails,
then MCU SW version does not match phone HW and user should flash MCU SW and
PPM for correct ROM version.
Phone Type Selection dialog
NOTE: This is a screen sample, actual information may differ.
Dialog mode: modal.
Phone Type Selection dialog has following items:
Phone Type group:
List box:
User can select phone type.
OK button (ENTER):
User accepts selected phone type.
Cancel button (ESC):
Phone type selection is cancelled and operation is aborted.
Issue 1 06/00 ãNokia Mobile Phones Ltd.
Service Software Instructions
NSB-7
Page 89