Nokia NSB-7 Series Service Manual page 154

NSB-7
Service Software Instructions
synthesizer channel numbers are as given with Channel/Monitoring Channel
selections
if Active Unit is TX, data (selected with TX Data Type) is sent and the TX power is
connected
Note! Function is activated immediately, Apply is not needed.
TX Data Type drop list (ALT+D):
This list changes the transmission data type. List consists following options: 0, 1,
Random. After Random data selection 0 is used. If Operating Mode is continuous, TX
Data Type Random causes different data sending than in burst mode.
TX Power Level edit box (ALT+T):
With this value is possible to change the transmission power. The user can give the
needed power value or select the test value, which is tuned with TX power tuning
function. The test value is found at the end of the list.
TX Power have value OFF and is disabled (greyed) when active unit is RX. When the TX
power is tuned with test value (smallest value) the TX Power has value TEST.
Channel edit box (ALT+H):
User can enter here channel number that is used for both transmission and receiving.
The frequency of the selected channel is shown after selection.
Monitoring Channel edit box (ALT+M):
This field selects neighbour monitoring channel. The frequency of the selected
channel is shown after selection.
Continuous Mode Channel edit box (ALT+C):
To this edit box user can type continuous mode channel which may have all
channel numbers.
The used frequency depends on the Active Unit. If Active Unit is RX, then RX
frequency is used, else TX frequency. The frequency of the selected channel is
shown after selection.
Gain Step Value edit box (ALT+L):
This selection allows user to set up the receiver gain step in continuous mode.
There are nine (0...8) steps (0...2 with LNA and 3...8 without LNA). In the burst
mode selection is automatic.
Page 48 ãNokia Mobile Phones Ltd.
PAMS Technical Documentation
Issue 1 06/00