Installing The Outer Door - Blomberg DWT14210 Installation Manual

If the enclosure height is above 33
(840mm) use "o" and "p" labelled toe kicks
together. Make sure the slotted toe kick "p" is
on the outside so you can adjust height of the
toe kick. Installation should be done following
the steps illustrated in the figures A, B and C
respectively.
1. Align the toe kick (o) and (p) (A).
2. Secure toe kicks to brackets with screws (t)
after adjusting the height of the slotted toe
kick (p) (B).
3. Attach caps (s) as shown in the supply bags
(C).
1 /
"
16

7.4 INSTALLING THE OUTER DOOR

(DWT 34200, DWT 35200, DWT 36200, DWT
37200, DWT 34400)
Measure the height and width of the enclosure
(Figure A) and the toe kick. Determine how big
the wooden door can be. For example if the height
7 /
is 33 " (860mm) and if the toe kick is 3
8
(100mm) the door can not be taller than 29
(760mm).
1. Prepare the wooden door with the mounting
brackets.
Height
(760mm)
Width
Thickness
17
USA
If the enclosure height is
1 /
below 33 " (840mm) use
16
only "o" labelled toe kick (toe
kick without slots). Installation
should be done following the
steps illustrated in the Figures
A, B and C respectively.
1. Bend tabs on toe kick (o)
inwards (A).
2. Secure toe kick to brackets
with screws (t) as shown in
the supply bags (B).
3. Attach caps (s) as shown in
the supply bags (C).
: Height of the wooden door 30"
: 23 ¼" to 23 ½" (592mm - 595mm)
: ¾ " (19mm)
15 /
"
16
15 /
"
16