Table of Contents
Advertisement
1.Bend tabs on toe kick (o) inwards (A).
2. Secure toe kick to brackets with screws (t) as shown
in the supply bags (B).
3. Attach caps (s) as shown in the supply bags (C).
If the enclosure height is above 331/16" (840mm) use
"o" and "p" labelled toe kicks together. Make sure the
slotted toe kick "p" is on the outside so you can adjust
height of the toe kick. Installation should be done
following the steps illustrated in the figures A, B and C
respectively.
1. Align the toe kick (o) and (p) (A).
2. Secure toe kicks to brackets with screws (t) after
adjusting the height of the slotted toe kick (p) (B).
3. Attach caps (s) as shown in the supply bags (C).
?
?
o
A
B
s
7.4 INSTALLING THE OUTER DOOR
(DIT25400, DIT28430, DIT29430)
Measure the height and width of the enclosure
(Figure A) and the toe kick. Determine how big
the wooden door can be. For example if the height
is 337/8" (860mm) and if the toe kick is 315/16"
(100mm) the door can not be taller than 2915/16"
(760mm).
A
3. Now attach the toe kick to the
bracket with the two (Ø 3/16" x
1/4" - Ø 4mm x 6mm) screws and
the caps provided as follows.
If the enclosure height is below
331/16" (840mm) use only
"o" labelled toe kick (toe kick
t
without slots). Installation
should be done following the
steps illustrated in the Figures A,
C
B and C respectively.
17
USA
A
o
p
B
t
C
s
Advertisement
Table of Contents
