Installer Checklist; Final Instructions; Self Help Hints - Blomberg DWT14210 Installation Manual

8. INSTALLER CHECKLIST

Your installer must have completed and
checked the following:
• The dishwasher is square and level.
• The dishwasher is fastened securely to
the cabinetry.
• The dishwasher door opens and closes
freely. The dishwasher door must close
without hitting any cabinetry or counter
top.
• The inlet water supply is turned on and
checked for leaks.
• The drain hose has been connected and
checked for leaks. There must be no
kinks or obstructions in the drain hose.
• The drain hose must be installed with a
28" (710mm) high drain loop for drain
hook-ups without any air removed.
• If the dishwasher drain is hooked up to a
garbage disposal, the drain hopper plug
must be removed.
• The spray arms are free and rotate freely.
• The rinse cycle has been run.
• The water level will be below the
filter screen after the end of the wash
program. It is normal to find some water
in the drain filter area.
• Set the water softener to the correct
water hardness for your area. If the
dishwasher drain is connected to a
garbage disposal, make sure that the
drain/hopper plug has been removed.

9. FINAL INSTRUCTIONS

1. Press the On/Off button to turn the
dishwasher on.
2. Power indicator light comes on.
3. Use the Cycle Select button to choose a
washing program.
4. Start the program with the Start/Pause
button.
5. Run the dishwasher through one
complete cycle. When the progress
indicator light "End" lights up, the wash
cycle is completed. Use the On/Off button
to turn the dishwasher off.
Notice :
If the dishwasher does not operate properly,
refer to the self help hints.

10. SELF HELP HINTS:

The power indicator light doesn't come on:
• Check to make sure the breaker to the
dishwasher is in the on position.
• Check all the wire connections in the
junction box are tight and not loose.
No Water is coming into the dishwasher:
• Check to make sure the hot water shut-
off is in the ON position.
Water does not drain:
• Make sure drain hose is not kinked or
comes out of air gap next to the sink.
• Remove drain hose from disposal making
sure plug is removed.
Notice :
• If your dishwasher is not operating
properly after following these steps:
Contact your dealer to schedule an
authorized service agent to inspect your
new dishwasher for any function related
failure.
• The manufacturer warranty does not
cover installation or customer education
service visits.
You will find the model and serial number
information on the label located on the
right-hand side of the inner door of your
dishwasher, as shown above.
Notice :
Please make a copy of your invoice and
keep it with this manual and register your
dishwasher on-line.
23
USA