Maintenance Schedule - Star Trac 4-TR Owner's Manual

MAINTENANCE SCHEDULE

The safety and integrity of this machine can only be maintained when the equipment is regularly examined for
damage and wear and repaired. It is the sole responsibility of the owner of this equipment to ensure that regular
maintenance is performed. Worn or damaged parts must be replaced immediately or the equipment removed
from service until the repair is made.
Some types of PM need to be performed more often than others. The frequency of PM depends a great deal on
the use and environment of the unit. Basic scheduling is shown below, but timeline and PM schedules should
be adapted to the environment and usage that the unit receives. Refer to the OpenHub Manual for further
maintenance information on the console.
Maintenance Schedule
Cleaning
Wipe down all surfaces
Wipe Moving Surface with dry cloth
2
Clean Console
3
Elevate unit and vacuum underneath
Clean underside of Moving Surface and lubricate with
silicone
Unplug unit and vacuum underneath motor shroud
General Maintenance
Check tracking to assure moving surface stays centered
Check Condition of Power Cord
Check drive belt tension
Check moving surface tension, adjusting if needed
Check all settings and Keypad Performance
Calibrate Elevation & Speed
Check Moving Surface and Deck Condition and replace
if wear found
2 Earlier documentation may refer to the moving surface as the 'running belt'.
3 Wipe console with a soft, non-abrasive cloth to remove all sweat after each use. Use a soft, non-abrasive cloth and mild spray cleanser to clean the
console. Never use abrasive cleaning liquids, cleaning liquids with an oil base, ammonia, or alcohol.
4 Ensure the power cord is not under the treadmill and is positioned away from the elevation screws. This will prevent the power cord from being pinched
or from binding up the elevation screws.
4
Daily Weekly Monthly
X
X
X
X
X
X
X
X
X
X
Every 6
Months Yearly
X
X
X
Page 35