Chicco Neptune Instructions For Use Manual page 12

fer to the cleaning instructions on seat fabric label which
illustrates the following washing symbols:
Machine washable at 30°
Do not bleach
Do not spin dry
Do not iron
Do not dry clean
Never use abrasive detergents or solvents. Do not spin
dry the fabric cover, let it dry without wringing.
To remove the various sections of the fabric cover from
the child car seat frame, follow the instructions below:
1. Release the child car seat harnesses from the buckle
(diag. 14)
2. Rotate and release the two belt locking plates R found
under the seat (diag. 20A) sliding them out of the two
slots in the fabric cover (diag. 20B).
3. Pull the cover up over the headrest and remove (diag.
34).
4. To remove the backrest cover, open the velcro faste-
ners and slide out the two harness straps (diag. 35).
5. Place the child car seat on a flat surface so that the lo-
wer part of the seat can easily be accessed (diag. 36).
6. Rotate the two release levers on the backrest T as seen
in the diagram (diag. 37)
7. Remove the backrest from the child car seat (diag. 38).
8. Remove the seat cover by opening the velcro faste-
ners and the two zips (diag. 39).
To replace the parts of the fabric cover, follow the above
instructions in the reverse order.
HOW TO CLEAN THE PLASTIC OR METAL PARTS
Clean the plastic and coated metal parts only with a
damp cloth. Never use abrasive detergents or solvents.
The movable parts of the child car seat must not be lu-
bricated.
CHECKING THE CONDITION OF THE COMPO-
NENTS
It is recommended to check regularly the condition of
the following components to ensure that they are not
damaged or worn out:
• Lining: check that the padding does not come out
from the seams. Check the condition of the seams:
they must always be intact and undamaged.
• Harnesses: Check that the fabric weft is not frayed or
the harness strap worn out in the parts corresponding
to the adjustment strap, crotch, shoulders and har-
ness adjustment plate.
• Plastic parts: Check that the plastic parts are not worn
out, damaged or faded.
WARNING! If the child car seat is deformed or worn out,
it must be replaced: it may no longer comply with the
original safety standards.
STORING THE PRODUCT
When it is not fitted into the car, it is recommended to
store the child car seat in a dry place, away from sources
of heat and to protect it from dust, humidity and direct
sunlight.
DISPOSING OF THE PRODUCT
When the child car seat no longer complies with the
original safety standards, stop its use and dispose of it at
an appropriate collection point. Dispose of the product
as laid down in the environmental regulations in force in
the Country of use.
10
F