Precor Energy Series Service Manual page 10

6. R20 Console: R20 Console: Perform the following R40 diagnostic tests:
•
Use the left/right arrow hardkeys to scroll and browse the test menu.
•
Press GO to start a test.
•
Use the WORKOUTS key as a BACK key to exit a test.
Test
Heart Rate Test
Beeper Test
Keypad Test
LCD Test
Machine Tests:
•
Belt Test
•
Incline Test The Incline test uses the INCLINE controls to verify ramp operation
Stop Key Test
7. From the Home screen, press the "QuickStart" softkey and verify SPEED and INCLINE
operation:
a. Adjust the SPEED from minimum to maximum range. Verify the belt operation is
normal (smooth, no unusual noises, etc.) and that the tracking remains centered.
Make sure the SPEED indicator is correctly displaying the belt speed. Reset the speed
to 0 mph (kph).
b. Adjust the INCLINE from minimum to maximum range. Verify the ramp incline
operation s normal (smooth, no glitches) and that the console INCLINE indicator is
displaying the correct incline level. Reset the incline level to 0 %.
8. Press QuickStart to start the belt, then press the STOP button. Verify that the running belt
immediately slows and stops.
9. Press QuickStart to start the belt, then use the Lanyard to pull the STOP button off the STOP
switch assembly. Verify that the running belt immediately slows and stops.
10. Go to the ERROR LOG and verify that no new error code events have occurred during these
tests (refer to the Error Log section). Resolve any new error codes and repeat the Operation
Verification procedure.
©2014 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
•
120 ±5 @ 5.5 % incline
•
242 ±5 @15% incline
Test the heart rate and SmartRate functions, the heart rate is
acquired and shown.
Test the beeper sound.
A map of the User keypad and Machine controls are shown on the
upper text window. Press a key and the corresponding LCD key light
will turn off.
To exit, press and hold the WORKOUTS key.
Cycles thru all the different functional areas of the LCD upper text
window and control indicators.
Performs tests to verify the Speed and Incline operation.
The Belt test uses the SPEED controls and running belt operation.
at 0.5 % increments.
Tests the press STOP key and the pull lanyard to remove STOP key
functions:
Both stop key operations will immediately slow and stop the running
belt.
Follow prompts to complete test.
Description
Page 10 of 56