Siemens SIMOTICS CONNECT 400 Manual page 2

Legal information
Warning notice system
This manual contains information that you must observe in order to ensure your own personal safety as well
as to avoid material damage. Notices relating to your personal safety are highlighted by a warning triangle;
notices relating to material damage only do not have a warning triangle. Depending on the hazard level,
warnings are indicated in descending order as follows.
DANGER
Indicates that death or severe personal injury will result if proper precautions are not taken.
WARNING
Indicates that death or severe personal injury may result if proper precautions are not taken.
CAUTION
Indicates that minor personal injury may result if proper precautions are not taken.
NOTICE
Indicates that material damage may result if proper precautions are not taken.
If more than one level of danger exists, the warning notice for the highest level of danger is used. A warning
note in a warning triangle indicating possible personal injury may also include a warning note relating to
material damage.
Qualified personnel
The product/system described in this documentation may be operated only by personnel qualified for the
specific task in accordance with the relevant documentation, in particular its warning notices and safety
instructions. Qualified personnel are those who, based on their training and experience, are capable of
identifying risks and avoiding potential hazards when working with these products/systems.
Intended use of Siemens products
Please note the following:
WARNING
Siemens products may only be used for the applications described in the catalog and in the relevant technical
documentation. If third-party products and components are deployed, then they must be recommended or
approved by Siemens. These products can only function correctly and safely if they are transported, stored, set
up, mounted, installed, commissioned, operated and maintained correctly. The permissible ambient conditions
must be adhered to. The information in the associated documentation must be observed.
Trademarks
All names identified by the trademark symbol ® are registered trademarks of Siemens AG. Other designations
used in this document may be trademarks whose use by third parties for their own purposes could violate the
rights of the trademark owners.
Disclaimer of liability
We have checked that the contents of this document correspond to the hardware and software described.
Since deviations cannot be precluded entirely, we cannot guarantee full consistency. The information given in
this document is reviewed at regular intervals and any corrections that might be required will be made in the
subsequent editions.
Anwendungsbeispiel für SIMOTICS CONNECT 400 - Router Kit
2