Applying Reference Identification Labels - Siemens SIMATIC ET 200SP HA System Manual

5.3.3

Applying reference identification labels

Procedure
Proceed as follows to apply a reference identification label:
1. Break off the reference identification labels from the sheet.
2. Insert the reference identification labels into the insert opening on the top of the modules:
– Interface module
– BusAdapter
– I/O module
– Slot cover
Figure 5-2
Modules for devices in a hazardous area
System Manual, 04/2021, A5E50165138-AA
①
Reference identification labels
②
Opening for label
Applying reference identification labels
5.3 Identification of components of the Ex module group
Installation
61