Greenheck DC Installation, Operation And Maintenance Manual page 10

5. Slide the mount cover over the downtube until it
rests on top of the upper motor cover. Make sure TOP
MOTOR COVER
that the mount cover is positioned so that the
cavity is facing up.
6. Slide the mounting ball over the downtube and
align the hole in the ball with the hole in the top of
the downtube. Insert the mounting ball pin through
the hole, then tighten the set-screw inside the
MOUNT ASSEMBLY
groove on the mounting ball using the provided
5/64 in. hex key.
MOUNT
BALL
DOWNTUBE
RING
MOUNT
COVER
7. Hang the motor/hub assembly from the universal
mount by inserting the downtube through the
opening in the side of the mount.
IL BLADE
10 Overhead Ceiling Fans
M4 - 0.7 x 10
MACHINE SCREW
0.25 x 2
STEEL DOWEL PIN
#8 - 32 x 0.25
SET SCREW
MOUNT ASSEMBLY
MOUNT ASSEMBLY
8. Align the tab on the universal mount so that it sits
inside the groove on the mounting ball.
9. Place a level against the downtube and adjust the
angle of the downtube until the fan is level. Make
sure that the tab on the universal mount remains
inside the groove on the mounting ball.
IMPORTANT: The tab on the universal mount must be
inside the groove on the mounting ball to prevent fan tilt,
swaying, and other unsafe operation conditions.
DEAD END
MOUNT
COVER
3 in.
MOUNT ASSEMBLY
HUB
HUB RETENTION
BRACKET
AIRFOIL BLADE
MOUNT A
®