Connection/Installation; Cautions; Parts List For Installation - Alpine CDE-172BT Owner's Manual

Connection/Installation

Cautions

• Run all ground (earth) leads to a common
ground (earth) point.
• Do not get the leads trapped under a screw, or
caught in moving parts (e.g., seat railing).
• Before making connections, turn the car
ignition off to avoid short circuits.
• Connect the yellow and red power supply
leads only after all other leads have been
connected.
• Be sure to insulate any loose unconnected
leads with electrical tape for safety.
Precautions
• Choose the installation location carefully so
that the unit will not interfere with normal
driving operations.
• Avoid installing the unit in areas subject to
dust, dirt, excessive vibration, or high
temperature, such as in direct sunlight or near
heater ducts.
• Use only the supplied mounting hardware for a
safe and secure installation.
Note on the power supply lead (yellow)
When connecting this unit in combination with other
stereo components, the amperage rating of the car
circuit to which the unit is connected must be higher
than the sum of each component's fuse amperage rating.
Mounting angle adjustment
Adjust the mounting angle to less than 30°.
36
-EN

Parts List for Installation

For CDE-172BT/UTE-73BT
• This parts list does not include all the package
contents.
• The bracket and the protection collar
attached to the unit before shipping. Before
mounting the unit, use the release keys
remove the bracket
details, see "Removing the protection collar and
the bracket" (page 41).
• Keep the release keys
are also necessary if you remove the unit from
your car.
× 2
5 × max. 8 mm
(7/32 × max. 5/16 in)
× 4
are
to
from the unit. For
for future use as they