Alpine CDE-172BT Owner's Manual page 10

Pairing and connecting with a
BLUETOOTH device
When connecting a BLUETOOTH device for the
first time, mutual registration (called "pairing") is
required. Pairing enables this unit and other
devices to recognize each other. This unit can
connect two BLUETOOTH devices (two cellular
phones, or a cellular phone and an audio device).
1
Place the BLUETOOTH device within
1 m (3 ft) of this unit.
2
Press and hold
seconds, rotate the control dial to select
[BLUETOOTH], then press it.
3
Rotate the control dial to select
[PAIRING], then press it.
4
Rotate the control dial to select [SET
DEVICE 1] * or [SET DEVICE 2]
it.
flashes while the unit is in pairing standby
mode.
* [SET DEVICE 1] or [SET DEVICE 2] will be changed to
the paired device name after pairing is complete.
5
Perform pairing on the BLUETOOTH
device so it detects this unit.
6
Select [CDE-172BT] [UTE-73BT] (your
model name) shown in the display of the
BLUETOOTH device.
If your model name does not appear, repeat
from step 2.
10
-EN
/SETUP for at least 2
* , then press
7
If passkey * input is required on the
BLUETOOTH device, input [0000].
* Passkey may be called "Passcode, " "PIN code, " "PIN
number" or "Password, " etc., depending on the
device.
Input passkey
[0000]
When pairing is made,
8
Select this unit on the BLUETOOTH
device to establish the BLUETOOTH
connection.
or lights up when the connection is
made.
Note
While connecting to a BLUETOOTH device, this unit
cannot be detected from another device. To enable
detection, enter the pairing mode and search for this unit
from another device.
To start playback
For details, see "Playing a BLUETOOTH Device
(CDE-172BT/ UTE-73BT only)" (page 16).
To disconnect the paired device
Perform steps 2 to 4 to disconnect after this unit
and the BLUETOOTH device are paired.
Connecting with a paired BLUETOOTH
device
To use a paired device, connection with this unit
is required. Some paired devices will connect
automatically.
1
Press and hold
seconds, rotate the control dial to select
[BLUETOOTH], then press it.
2
Rotate the control dial to select [BT IN],
then press it.
Make sure that lights up.
stays lit.
/SETUP for at least 2