System Signaling Tones - Siemens HiPath 1100 User Manual

Using the HiPath 1100 Features
Note:
The number of external lines and extensions available depends on the system's configura-
tion.

System Signaling Tones

During feature configuration the system uses the following signaling tones:
Tone
Internal dialing tone
Signaling tone
Dial tone
Busy signal
External false signal
Call waiting signaling tone
Call waiting tone for door
opener
Confirmation tone
Rejection tone
Override tone
Conference tone
Callback confirmation tone
Alert signal
Special dial tone
Auto-Answering Tone
12
Meaning
The system is ready to receive and send call information.
Connection established. Ring signal is being applied to
phone number.
Network accepted information request and is sending a re-
quest for further information.
It indicates to the caller that the number is busy.
It is also used when the destination cannot be accessed
(e.g., invalid number).
The line tone heard is not the tone sent by the carrier.
It indicates to the user having a conversation that there is
another call ringing.
It indicates to the user having a conversation that someone
is requesting the door opener to open the door.
The procedure was successfully completed and accepted.
The procedure is invalid and was not accepted.
It alerts the user having a conversation that the call's priva-
cy was violated (override).
It indicates that a new participant joined the conversation.
It confirms a callback.
It alerts the called party when the speakerphone Auto-An-
swering and Paging features are activated.
Indicates that a service is activated (Night Service, elec-
tronic lock, Do not disturb, etc.)
After a Direct Communication Call is established.