Kurzweil PC3 Musician's Manual Addendum page 55

Within the Setup Editor, you can also set a PC3 physical controller to send a CC number to a
program on a zone. If this is done with a InputChannel set, you will also be able to control a
parameter by sending the default CC number for that physical controller to the channel set for
InputChannel. The table below lists the default CC number used to control the assignments of
PC3 physical controllers while in Setup Mode.
Also, for each physical controller, if a CC# is listed in the "Additional MIDI CC# Which Always
Controls The Parameter Assigned To Each PC3 Physical Controller In Setup Mode" column,
then that physical controller's assignment can always be controlled by the CC# listed in that
column. For physical controllers where this is the case, the physical controller's assignment will
respond to the CC# listed in the "Additional MIDI CC# Which Always Controls The Parameter
Assigned To Each PC3 Physical Controller In Setup Mode" column, as well as the physical
controller's default CC number.
PC3 Physical Controller
Pitch Wheel
Mod Wheel
Arp Button
SW Button
Continuous Pedal 1
Continuous Pedal 2
Breath
Pressure (key pressure)
Foot Switch 1
Foot Switch 2
Foot Switch 3
Ribbon Section 1
Ribbon Section 2
Ribbon Section 3
Slider A (Data)
Slider B
Sliders C-I
Programable Switches 1-8
External MIDI CC Remapping
Default MIDI CC# Which
Controls The Parameter
Assigned To Each PC3
Physical Controller In
Setup Mode
NA, responds to MIDI pitch
bend messages
1
No Default
29
11
4
2
No Default
64
66
67
21
No Default
No Default
6
13
22-28
No Default
MIDI Mode
The RECEIVE Page
Additional MIDI CC#
Which Always Controls
The Parameter Assigned
To Each PC3 Physical
Controller In Setup Mode
None
None
69
70
None
None
None
None
None
None
None
18
19
20
None
None
None
None
6-7