Yaesu FT-70DR Instruction Manual page 30

• Step
Sets the channel step for receiving channels. Normally, when a frequency is entered, the optimal channel
step will be automatically set according to the frequency.
• TAG
Setting the memory tag, the checkbox of TAG is automatically ticked. When recalling this memory chan-
nel, the set memory tag is displayed. By Turning off the checkbox, the receive frequency is displayed in-
stead of the memory tag.
• ATT
By ticking the checkbox of this item, the receive sensitivity is lowered by about 10dB. This is useful when,
for example, an adjacent strong radio wave interferes with the reception.
• S Meter SQL
Configure the normal noise squelch setting, and also the S-meter squelch level setting.
• BELL
Outputs a ringing tone when receiving a signal that satisfies the conditions set from the squelch type.
Set the number of times the tone (bell) rings.
• Half DEV
Lowers the transmit deviation to approximately half.
• Clock Shift
When an internal spurious signal occurs due to the microcomputer clock, turn this setting on (tick the
checkbox). This may improve the situation.
Usually, this item is set to "OFF" (un-tick the checkbox).
• Comments
Comments may be added to the edited HOME channels. Up to 255 letters can be used. This function is
useful in organizing the HOME channels by, for example, applying a category name to each channel.
These comments are not transferred to the FT-70DR/DE.
ADMS - 10 Instruction Manual
29