Yaesu FT-70DR Instruction Manual page 10

7. Click the [Browse] button, then select the folder in
which you saved the extract the downloaded file in in-
stalling the ADMS-10, and then click the [Next] button.
8. Click "Close" when the below illustrated screen is dis-
played.
9. Check that "FT-70D communication device (COMxx)" is appears under "Ports (COM & LPT)".
• When displayed , the driver update has been completed successfully. If not displayed, try again
from step 1.
• "XX" refers to a port number. Write down the port number.
10. Close the ADMS-10 and execute the ADSM-10 once again..
11. From the menu bar, select "Communications" menu, and then click on the "COM port Settings",
then select the port number of wrote down in step 9.
• To finish the installation, close the ADMS-10, and turn off the FT-70DR/DE, then disconnect the
cables.
ADMS - 10 Instruction Manual
9