Technical Data - Graco Pro 230ES Repair And Parts Manual

Technical Data

Working pressure range
Electric motor
Operating horsepower
Maximum delivery (with tip)
Paint hose
Maximum tip hole size
Weight, sprayer only
Weight, sprayer, hose & gun
Dimensions:
Length
Width
Height
Height (handle retracted)
Power cord
Fluid inlet fitting
Fluid outlet fitting
Inlet screen (on suction tube)
Wetted parts, pump & hose
Wetted parts, gun
Generator requirement
Electrical power requirement
Storage temperature range ◆❖
Operating temperature range ✔
◆ When pump is stored with non-freezing fluid. Pump damage will occur if water or latex paint freezes in pump.
❖ Damage to plastic parts may result if impact occurs in low temperature conditions.
✔ Changes in paint viscosity at very low or very high temperatures can afftect sprayer performance.
3A2817A
Pro 230ES
0-3000 psi (0-21 MPa, 0-207 bar)
11.0A (120 VDC)
(permanent magnet DC, TEFC)
1.0
0.54 gpm (2.05 lpm)
1/4 in. x 50 ft (6.4 mm x 15 m)
0.023 in. (0.58 mm)
66 lb (30 kg)
69 lb (31.4 kg)
16 AWG, 3-wire, 10 ft (3.05 m)
7/8" - 14 UNF external thread
zinc-plated carbon steel, nylon, stainless steel, PTFE, acetal, chrome plating,
leather, UHMWPE, aluminum, carbide
aluminum, brass, carbide, nylon, plated steel, stainless steel, UHMWPE, zinc
120 Vac, 60 Hz, 11A, 1 phase
(Permanent magnet brushless DC, TEFC)
0.70 gpm (2.65 lpm)
0.027 in. (0.69 mm)
21 in. (53.3 cm)
20.5 in. (52.1 cm)
39.5 in. (100.3 cm)
29.5 in (74.9 cm)
14 AWG, 3-wire, 10 ft (3.05 m)
1/4 NPSM external thread
#12 mesh (1675 micron)
3000 Watt minimum
-30° to 160°F (-35° to 71°C)
40° to 115°F (4° to 46°C)
Technical Data
Pro 270ES
5.5A (330 VDC)
1.4
72 lb (33kg)
75 lb (34 kg)
45