Power Cord; On/Off Switch - Graco Pro 230ES Repair And Parts Manual

Pro 270ES ON/OFF Switch/Power Cord Kit
Removal
1. Relieve pressure, page 9.
2. Unplug sprayer powercord.
3. Remove four screws (12) and control box cover (50).

Power Cord

4. Remove green ground screw (19) and disconnect
ground choke coil and black leads.
5. Slide black power cord strain relief (a) out of slot in
control box (48) to remove it.

On/Off Switch

6. Remove switchboard mounting screw (6)
7. Using a 5/8 in. deep socket wrench, remove
ON/OFF switch toggle boot (58).
8. Slide switch board (30) through opening in control
box housing.
9. Disconnect black lead between control boards.
10. Remove switch board from box.
12
3A2817A
58
a
30
6
50
Installation
1. Reconnect black lead between control and switch
boards.
2. Slide ON/OFF switch board (30) through opening in
control box housing and position switch board.
3. Place toggle boot (58) over ON/OFF switch. Using a
5/8 in. deep socket wrench, tighten securely.
4. Install switchboard mounting screws (6).
5. Slide power cord strain relief (a) into opening in con-
trol box (48).
6. Reattach black and white power cord leads to con-
trol and switch boards.
7. Reattach ground choke coil to ground screw (19).
Replace and tighten green ground screw.
8. Install pressure control cover (50) with four screws
(12).
48
19
On/Off Switch Replacement
ti7433a
27