F Functions; Functions Turning On The Unit; Functions With Ptt Switch - PRESIDENT ADAMS FCC Owner's Manual

C) EXTERNAL SPEAKER JACK (8 Ω, Ø 3,5 mm)
D) PA SPEAKER JACK (8 Ω, Ø 3,5 mm)
C) F FUNCTIONS
First make sure that the priority channel is not selected and that
"EMG" is not displayed. 2 functions are available.
1) ROGER BEEP
(s key)
The ROGER BEEP sounds when the PTT switch (8) of the microphone
-
is released in order to let his correspondent know that it was his
turn to talk. Historically as CB is a "simplex" communication mode,
it is not possible to speak and listen at the same time (as it is the
case with a telephone). Once the conversation was over, he said
"Roger" in order to prevent his correspondent that it was his turn to
talk. The word "Roger" has been replaced by a significant beep.
That is where the name "Roger beep" comes from.
Use the following procedure to activated or deactivated the
ROGER BEEP function:
Long press the F (5) until
-
F (5) key and short press the s (2a) key to activate/deactivate
the ROGER BEEP function.
- When the function is activated, " " appears on the display.
Note: The Roger beep also sounds in the loudspeaker if the KEY
BEEP function is active. If the KEY BEEP function is not active, only
the correspondent can hear the ROGER BEEP.
In PA mode the function is not allowed.
2) KEY BEEP
(t key)
- Some operations such as changing channels, pressure on keys etc.
are confirmed by a beep tone. This beep tone can be activated
or deactivated as follows:
Long press the F (5) until
-
F (5) key and short press the t (2b) key to activate/deactivate
the KEY BEEP function.
When the function is activated, "BP" appears on the display.
-
appears on the display. Release the
appears on the display. Release the
D) FUNCTIONS TURNING ON THE UNIT
2 functions are available. Turn off the unit. Turn on the radio while
pressing one or two keys to set the function.
1) MICROPHONE TYPE
(s key)
Your ADAMS FCC allows you to use a dynamic or electret micro-
phone. To select the type:
- Turn on the power while pressing the s (2a) key. The symbol of
the current microphone type dY
displayed. Repeat this action to set the correct microphone type.
Original 4 pins PRESIDENT microphone is electret type.
2) COLOR
(EMG + CB/PA keys)
- Turn on the power while pressing the EMG (5) and CB/PA (6) keys.
Symbol of the current color, among the seven, blinks:
(green), (blue),
light).
- Use the s/t keys (2) to change the color.
When the color is set, long press the F key (5) or press the PTT switch
-
(8) to validate. Beep sounds. the symbol of the setted color is
shown during 1 second.
E) FUNCTIONS WITH PTT SWITCH
2 functions are available. To activated the function press and hold
the PTT switch (8) and press the function key.
1) TALKBACK
(PTT + F)
The TALKBACK function can be activated or deactivated as follows:
a) Press and hold the PTT switch (8)
b) Short press on F key (5). Current TALKBACK level blinks 3 times
allowing you to adjust this level.
When the function is activated, "TB" appears on the display.
This function allows to ear your own modulation with the CB speaker.
9
(dynamic) or EL
na eC
(cyan), (yellow), (purple) or
(electret) is
(orange),
(cyan