Ariens Sno-Thro Compact Series Service Manual page 28

5. Install traction drive belt onto traction drive sheave and
around traction pulley. See Figure 47.
See Figure 48.
6. Reinstall support bushing onto swing gate pivot rod.
7. Reinstall spring clip into pivot rod.
NOTICE: Support bushing MUST be correctly seated in
and flush with frame.
8. Reinstall swing gate spacer and align with support
bushing. Secure with two tapping screws.
1. Support Bushing
2. Swing Gate Spacer
Figure 47
1
2
Figure 48
See Figure 49.
9. Reinstall idler spring onto traction drive idler.
10. Reinstall swing gate return spring onto frame.
11. Reinstall housing to frame. See Reinstall Auger
Housing on page 9.
12. Adjust traction drive clutch. Refer to Operator's
Manual for adjustment procedure.
13. Reconnect spark plug wire.
IMPORTANT: Check all adjustments after first use.
EN – 24
Figure 49