Ariens Sno-Thro Compact Series Service Manual page 20

See Figure 27.
3. Position torsion spring leg around attachment idler
arm.
IMPORTANT: Ensure idler arm has tension.
See Figure 28.
4. Reinstall flat washer, wave washer and clutch arm
onto attachment idler pivot rod.
IMPORTANT: Ensure wave washer is reinstalled with
concave surface positioned against flat washer.
5. Secure clutch arm to attachment idler pivot rod with
original tapping screw.
6. Reinstall auger housing to frame. See Reinstall Auger
Housing on page 9.
7. Adjust attachment drive clutch. Refer to operator's
manual for instructions.
8. Reconnect spark plug wire.
IMPORTANT: Check all adjustments after first use.
Figure 27
Figure 28
WARNING: AVOID INJURY. Auger / impeller
must stop within 5 seconds when attachment
clutch lever is released.
EN – 16