Removing The Door Assembly And Door Components - Whirlpool W11440958 Technical Manual

COMPONENT ACCESS (Cont.)

Removing the Door Assembly and Door Components

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
To Remove the Door Assembly
1. Open door (see Figure 1).
2. Use a TORX T-20 driver to remove the two (2) hinge
®† ®
screws (see Figure 2).
3. Lift up door assembly to disengage hinge from the front
panel. Remove door assembly (see Figure 3).
†®TORX and T-20 are trademarks of Acument Intellectual Properties, LLC.
4-2 Whirlpool 24" Compact Condensing Dryer
n
®
Figure 1
Figure 2
Figure 3
To Remove the Door Strike Assembly
1. Open door (see Figure 1).
2. Using a flat-blade screwdriver, insert the screwdriver as
shown in Figure A below. At the same time, push down on
the strike until it unclips from the door (see Figure B).
Remove the strike assembly from the door.
Figure 1
Figure A
Figure B