Removing The Front Panel And Door Switch - Whirlpool W11440958 Technical Manual

To Remove the Drain Pump
1. Disconnect the drain pump wire connector and unclip it
from retainer shown in Figure 9. Replacement drain pump
comes pre-attached to support bracket assembly.
To Remove the Front NTC
1. Disconnect the harness as shown in Figure 10.
2. Pull NTC straight out to remove (it is press fit in place).
Figure 9
Figure 10
COMPONENT ACCESS (Cont.)
Removing the Front Panel and
Door Switch
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
To Remove the Front Panel
1. Unplug dryer or disconnect power.
2. Perform the procedure on
Assembly" prior to performing the following steps.
3. Perform the procedure on
Panel" prior to performing the following steps.
4. Perform the procedure on
Panels" prior to performing the following steps.
5. Perform the procedure on
console/User Interface" prior to performing the following
steps.
6. Remove the four (4) T20 screws and repeat on other side
(see Figure 1).
7. Remove two (2) T20 screws as shown in Figure 2.
Whirlpool 24" Compact Condensing Dryer
®
page 4-2. "Removing the Door
page 4-4, "Removing the Top
page 4-4, "Removing the side
page 4-8. "Removing the
Figure 1
Figure 2
4-17
n