Belkin F6D3230-4 Software Setup Manual page 12

Modifying your Parental Control Policies
A list of 59 categories is provided to give a wide array of
customizable options for Parental Control. Categories can be blocked
or allowed. Blocked categories have been set up by default, so initial
use of Parental Control will immediately begin blocking websites that
could be objectionable. You can modify the categories at any time
you wish. Additionally, any website can be set to always be allowed,
or always blocked, regardless of the category.
There are two ways to get to the policy administration site.
1. Every time access to a blocked website is attempted, a Policy
Violation screen will be shown. These screens offer a link to the
Policy Administration page, and require the Parental Control
password be entered for access.
2. There is a link in the Router firmware Parental Control page to the
Policy Administration page. The Parental Control password will
be required.
After logging into the Policy Administration site, choose one of
the following:
1. "Policy Administration" tab to choose which categories to block.
2. "Overrides" tab to enable specific URLs to either be "always
blocked" or "always allowed", regardless of policy settings.
3. "Reporting" tab (if you have purchased a subscription to
Reporting). Clicking this tab will allow you to review web-surfing
history, both for blocked and allowed sites.
Note: If a single computer overrides Parental Control for one
hour, or if Parental Control is turned OFF on the Router, web
access during these periods will not produce history information
in reporting.
9
1
2
3
4
5
6
7
8
9
10