Using Your Switch; Selecting A Computer Using Direct-Access Port Selectors; Selecting A Computer Using Keyboard Hot Key Commands - Belkin OmniView F1DH102U User Manual

You can select which computer to operate by either the direct-access port
selector located on the front panel of the Switch or through keyboard hot
key commands. Note that it will take 1–2 seconds for the video to display
after switching. This is due to the refresh rate of the video signal. There
is also re-synchronization of the mouse and keyboard signal that takes
place. This is normal operation and ensures that proper synchronization is
established.

Selecting a Computer Using Direct-Access Port Selectors

You can directly select which computer you wish to control by pressing
the corresponding direct-access port selector next to the appropriate
port. The LED will be lit to indicate that the port is currently selected.

Selecting a Computer Using Keyboard Hot Key Commands

Note: You must connect the USB keyboard to the designated USB
connector to have keyboard hot key switching function on
the keyboard.
You can command the Switch to switch ports with a simple keyboard
command sequence by using the [SCROLL LOCK] key and [UP], [DOWN]
arrow keys. To send commands to the Switch, the [SCROLL LOCK] key must
be pressed twice within two seconds. You will hear a beep for
confirmation. Then you can press the [UP], [DOWN] arrow keys to switch
between ports.
Switch to next active port,
[UP] arrow
You can switch directly to any port by entering the port number of the port
you wish to use. For example, if you press [SCROLL LOCK], [SCROLL LOCK],
[2], the computer on port 2 will be selected.
Switch to port 2—#2 key

USING YOUR SWITCH

Switch to previous active port,
[DOWN] arrow
Switch to port 4—#4 key
14