Belkin OmniView F1DA104Pea User Manual page 24

Using your PRO2 PS/2
AutoScan Time:
Specifies the amount of time the PRO2 PS/2 remains on a port before
switching to the next port while in AutoScan mode. You may select
different time intervals—7, 15, 30, or 60 seconds. Use the OSD to set the
AutoScan time interval.
OSD Display Time:
Specifies the amount of time the OSD menu is displayed. Also specifies
the amount of time the "Port Identification" tag displays on-screen after
making a port selection. You may choose 7, 15, 30, or 60 seconds. For
both settings, you may use the arrow keys to navigate. After you have
selected the desired time intervals, push "Enter" key to save the entry.
Press the "ESC" key to go back to the original OSD menu screen.
Press the "ESC" key again to exit the On-Screen Display completely.
Once you have selected a computer on the menu, press "Enter" to switch
to that port.
Note:
If there are Slave units connected, and the AutoScan time and OSD
display time settings are set on the Master unit, the settings will also
apply to all slave units.
Updating Firmware:
To update your firmware, download the appropriate firmware file and
utility from belkin.com. The utility automatically guides you through the
process of updating the firmware on your PRO2 PS/2.
Cautions and Warnings:
We strongly recommend that you update your firmware only if you are
currently experiencing mouse and keyboard problems with your PRO2
PS/2, as reconfiguring software may lead to unexpected operational
problems. Please contact Belkin Tech Support if you need assistance.
To update the firmware, you will need the following items:
1. A separate computer running Windows 95, 98, or Me. This computer
must not be connected to the CPU ports on the PRO2 PS/2.
2. An available parallel port on the computer.
3. A flash cable that connects between the PRO2 PS/2 and the computer.
4. Firmware update files available at belkin.com.
21
1
2
3
3
4
5
6
7
8
9
10