Belkin OmniView F1DA104Pea User Manual page 22

Using your PRO2 PS/2
The "BANK –" button will take you to the previous BANK. For example,
when you are at BANK 02 and want to check computers in BANK 01.
Pressing the "BANK –" button will take you to BANK 01. As default, the
first active computer will be displayed on the Console monitor. Use the
direct-access port selectors to go to the desired computer on BANK 01.
Keyboard Hot Key Commands:
Conveniently command the PRO2 PS/2 to switch ports through simple
keyboard key sequences. To send commands to the PRO2 PS/2, the
"Scroll Lock" key must be pressed twice within two seconds. You
will hear a beep for confirmation. Below is a complete list of hot key
commands:
Note:
you will have approximately five seconds to complete each hot key
sequence.
SL SL Up Arrow
SL SL Down Arrow
SL SL Page Up
SL SL Page Down
SL SL Y
(Single-Switch Configuration)
SL SL X
(Daisy-Chain Configuration)
SL SL Delete
SL SL S
SL SL Space Bar
SL SL A
Switch to PREVIOUS ACTIVE port
Switch to NEXT ACTIVE port
Switch to PREVIOUS BANK
(By default, selects first active port
on the BANK)
Switch to NEXT BANK
(By default, selects first active port
on the BANK)
Directly switches to PORT Y on BANK 00
Y=01 to 16
Y Directly switches to PORT Y on BANK X
(X=00 to 15) (Y=01 to 04 for F1DA104T)
(X=00 to 15) (Y=01 to 08 for F1DA108T)
(X=00 to 15) (Y=01 to 16 for F1DA116T)
Reset On-Screen Display menu
Disable sound in AutoScan mode
Activate On-Screen Display
Enable AutoScan mode
(Refer to AutoScan button)
19
1
2
3 3
4
5
6
7
8
9
10